This file was downloaded from

Flower Looms: The Single Woven Centre


This video was made several years after writing the tutorial below and contains a lot of added information.

1: Pass your needle under the threads at the right hand side of the petal at the opposite side to the last petal you wound.

For example, the last petal I wound is at the bottom of the photo on the left. I am passing my needle under the threads that form the right hand side of the top petal.

2: Pass your needle under the same threads again. Your thread will form a loop.

3: Pass your thread through the loop to form a knot.

4: Pull the knot tight.

5: Working anticlockwise, pass your needle under the threads that form the right hand side of the next petal.

6: Repeat step 5 all the way around.

7: When you reach the first petal again, start passing your needle under the threads on the left hand side of each petal.

8: Continue weaving around your flower in this way, changing the side of the petal you are weaving under every time you reach the first petal.

9: To finish off your thread, pass it under the last set of threads again and

10: leave a loose loop.

11. Pass your thread through the loop and pull the knot tight.

Pop your flower off the loom and stitch the loose ends into the back.


Copyright Sarah Bradberry. All rights reserved. You may not edit, email, publish, or distribute the contents of this page in any form without the prior permission of the copyright holder. If you would like to share the information on this page you may do so by giving the link to this page which is http://knitting-and.com/small-looms/single-woven.htm