Ski Jumper (Sweater) and Leg Warmers for Beanie Babies

This file was downloaded from

Ski Outfit

The pattern for Beanie's 1ft stocking cap is also available.

Materials

Scraps of dk yarn in 3 colours. The sample uses white as the main colour, blue and white ragg as contrast colour 1, and dark blue as contrast colour 2.
Set of 4mm dpns and a set of 3.25mm dpns

Tension

22sts and 30 rows to 10cm over st st on 4mm needles

Ski Jumper

Body:
Using 3.5mm needles and contrast colour 1, cast on 56sts and work 6 rounds K1, P1 rib.

Change to 4mm needles and work 4 rounds following the chart below using your main colour and contrast colour 2.

Chart

Using main colour knit 4 rounds plain. Set aside while you knit the sleeves.

Sleeves (make 2):
Using 3.25mm needles and contrast colour 1 cast on 16sts and work 4 rounds K1, P1 rib.

Change to main colour and 4mm needles and knit 4 rounds. Cut yarn and put sts on a holder.
Make another sleeve in the same way but don't cut the yarn.

Joining the Sleeves and Body and Knitting the Yoke:
I find the best st holders to use on a piece this small are doubled lengths of yarn in a contrasting colour. They're totally flexible and they don't get in the way or pull your work out of shape.

Begin with the second sleeve (the one you didn't cut the yarn on) and work as follows:
K3 and place these 3sts just knit onto a st holder, K10, then place the remaining 3 sleeve sts on a holder.

Place 1st 3sts of the body on a st holder, K22, place next 6sts of body on a holder.
Pick up the next sleeve and put 3 sts on a holder, K10, then place last 3sts on a holder.
K22 sts across the back of the body and finally place the last 3sts of the body on a holder.
Place a marker to mark the end of the round.

1st round: Knit

2nd round: (K10, SSK, K18, K2tog) twice

3rd round: Knit

4th round: (K10, SSK, K16, K2tog) twice

5th round: Knit

6th round: (K10, SSK, K14, K2tog) twice

7th round: Knit

Change to 3.25mm needles and contrast colour 1 and work 3 rounds K1, P1 rib. Cast off.

Making Up

Sew in all loose ends and graft sts at underarm.

Leg Warmers (make 2)
Using 4mm needles and main colour cast on 18sts and work 8 rounds K1, P1 rib. Cast off and sew in loose ends.


This pattern and all images on this page are Copyright © Sarah Bradberry 1999. All rights reserved.